EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790942490	458 Count	876 Count	358 Count
1790941590	454 Count	865 Count	355 Count
1790940689	450 Count	853 Count	352 Count
1790939788	447 Count	848 Count	350 Count
1790938887	443 Count	832 Count	347 Count
1790937987	436 Count	815 Count	341 Count
1790937086	431 Count	808 Count	337 Count
1790936185	426 Count	801 Count	333 Count
1790935284	422 Count	795 Count	330 Count
1790934383	418 Count	789 Count	327 Count
1790933504	413 Count	782 Count	323 Count
1790932603	410 Count	776 Count	321 Count
1790931703	406 Count	770 Count	318 Count
1790930802	401 Count	763 Count	314 Count
1790929901	398 Count	750 Count	312 Count
1790929000	394 Count	740 Count	309 Count
1790928100	391 Count	723 Count	307 Count
1790927199	387 Count	709 Count	304 Count
1790926298	382 Count	701 Count	300 Count
1790925397	377 Count	693 Count	296 Count
1790924497	372 Count	685 Count	292 Count
1790923596	367 Count	677 Count	288 Count
1790922695	362 Count	669 Count	284 Count
1790921794	357 Count	661 Count	280 Count
1790920894	351 Count	652 Count	275 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)