EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1773710719	526 Count	184 Count
1773710119	518 Count	183 Count
1773709518	507 Count	179 Count
1773708918	497 Count	176 Count
1773708318	486 Count	173 Count
1773707718	475 Count	170 Count
1773707118	465 Count	165 Count
1773706518	455 Count	161 Count
1773705918	444 Count	156 Count
1773705318	435 Count	152 Count
1773704718	425 Count	149 Count
1773704117	410 Count	145 Count
1773703517	400 Count	140 Count
1773702917	390 Count	136 Count
1773702317	380 Count	132 Count
1773701717	360 Count	124 Count
1773701115	346 Count	120 Count
1773700515	337 Count	117 Count
1773699915	324 Count	111 Count
1773699315	313 Count	108 Count
1773698714	301 Count	105 Count
1773698114	287 Count	99 Count
1773697514	276 Count	96 Count
1773696914	263 Count	92 Count
1773696314	246 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)