EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1789064653	817 Count	445 Count
1789064053	801 Count	436 Count
1789063453	790 Count	428 Count
1789062853	773 Count	419 Count
1789062253	755 Count	410 Count
1789061653	742 Count	403 Count
1789061053	728 Count	397 Count
1789060452	712 Count	388 Count
1789059852	701 Count	381 Count
1789059252	678 Count	371 Count
1789058652	661 Count	363 Count
1789058052	648 Count	356 Count
1789057452	633 Count	347 Count
1789056852	609 Count	336 Count
1789056251	597 Count	328 Count
1789055651	595 Count	326 Count
1789055050	591 Count	322 Count
1789054450	573 Count	313 Count
1789053850	560 Count	306 Count
1789053250	541 Count	297 Count
1789052650	528 Count	290 Count
1789052050	511 Count	281 Count
1789051450	495 Count	272 Count
1789050850	487 Count	266 Count
1789050250	479 Count	261 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)