EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773170709	87 Count	617 Count	65 Count
1773168908	81 Count	601 Count	60 Count
1773165314	66 Count	572 Count	51 Count
1773163514	62 Count	558 Count	48 Count
1773161713	57 Count	540 Count	44 Count
1773158111	45 Count	472 Count	34 Count
1773156311	39 Count	408 Count	29 Count
1773154510	31 Count	345 Count	22 Count
1773152709	26 Count	245 Count	18 Count
1773150908	21 Count	163 Count	14 Count
1773147307	9 Count	59 Count	4 Count
1773141913	128 Count	909 Count	98 Count
1773140112	122 Count	847 Count	93 Count
1773138311	116 Count	781 Count	88 Count
1773136510	110 Count	724 Count	83 Count
1773134709	105 Count	662 Count	79 Count
1773132909	99 Count	588 Count	74 Count
1773131108	93 Count	526 Count	69 Count
1773125706	77 Count	350 Count	56 Count
1773123905	73 Count	268 Count	53 Count
1773122112	64 Count	211 Count	49 Count
1773120312	58 Count	192 Count	44 Count
1773118511	52 Count	163 Count	39 Count
1773116710	47 Count	145 Count	35 Count
1773114912	41 Count	125 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)