EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SN9GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN9GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1792921369	0 Count	86 Count
1792919568	7 Count	1013 Count
1792917767	6 Count	927 Count
1792915966	5 Count	823 Count
1792914166	4 Count	745 Count
1792912365	3 Count	637 Count
1792910564	2 Count	404 Count
1792908773	1 Count	301 Count
1792906972	0 Count	190 Count
1792905171	9 Count	1138 Count
1792903370	8 Count	976 Count
1792901569	7 Count	853 Count
1792899768	6 Count	741 Count
1792897967	5 Count	617 Count
1792896167	4 Count	489 Count
1792894366	3 Count	360 Count
1792892565	2 Count	252 Count
1792890764	1 Count	120 Count
1792888963	0 Count	0 Count
1792887172	6 Count	906 Count
1792885371	5 Count	782 Count
1792883570	4 Count	653 Count
1792881769	3 Count	531 Count
1792879969	2 Count	416 Count
1792878168	1 Count	283 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)