EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791233796	22 Count	256 Count	13 Count
1791231995	18 Count	197 Count	11 Count
1791230193	13 Count	163 Count	7 Count
1791228392	10 Count	122 Count	5 Count
1791226591	6 Count	67 Count	2 Count
1791224790	0 Count	0 Count	0 Count
1791223003	121 Count	999 Count	33 Count
1791221201	118 Count	916 Count	31 Count
1791219400	114 Count	847 Count	28 Count
1791217599	110 Count	779 Count	26 Count
1791215797	100 Count	706 Count	23 Count
1791213996	97 Count	615 Count	21 Count
1791212194	93 Count	524 Count	18 Count
1791210393	78 Count	409 Count	16 Count
1791208592	73 Count	319 Count	12 Count
1791206791	70 Count	249 Count	10 Count
1791204989	66 Count	188 Count	7 Count
1791203188	56 Count	132 Count	5 Count
1791201403	2 Count	63 Count	2 Count
1791199602	199 Count	1011 Count	66 Count
1791197801	195 Count	950 Count	63 Count
1791195999	192 Count	903 Count	61 Count
1791194198	188 Count	863 Count	58 Count
1791192396	182 Count	810 Count	56 Count
1791190595	178 Count	766 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)