EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SN2DP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN2DP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767307607	394 Count	310 Count	207 Count
1767306707	392 Count	307 Count	206 Count
1767305806	390 Count	303 Count	205 Count
1767304905	388 Count	299 Count	204 Count
1767304005	385 Count	295 Count	202 Count
1767303104	384 Count	294 Count	202 Count
1767302204	380 Count	289 Count	199 Count
1767301303	376 Count	284 Count	196 Count
1767300402	372 Count	279 Count	193 Count
1767299501	369 Count	276 Count	191 Count
1767298632	368 Count	275 Count	191 Count
1767297731	366 Count	273 Count	190 Count
1767296831	363 Count	270 Count	188 Count
1767295930	360 Count	268 Count	186 Count
1767295030	359 Count	268 Count	186 Count
1767294129	356 Count	264 Count	184 Count
1767293228	354 Count	262 Count	183 Count
1767292328	352 Count	260 Count	182 Count
1767291427	351 Count	260 Count	182 Count
1767290526	349 Count	259 Count	181 Count
1767289626	345 Count	256 Count	178 Count
1767288725	344 Count	256 Count	178 Count
1767287824	342 Count	255 Count	177 Count
1767286924	340 Count	254 Count	176 Count
1767286023	338 Count	253 Count	175 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)