EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SN2DP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN2DP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765084935	50 Count	11 Count	9 Count
1765084035	49 Count	11 Count	9 Count
1765083134	48 Count	11 Count	9 Count
1765082233	47 Count	11 Count	9 Count
1765081333	44 Count	8 Count	7 Count
1765080432	42 Count	7 Count	6 Count
1765079531	41 Count	7 Count	6 Count
1765078631	39 Count	6 Count	5 Count
1765077730	37 Count	4 Count	4 Count
1765076829	36 Count	4 Count	4 Count
1765075940	34 Count	3 Count	3 Count
1765075040	32 Count	2 Count	2 Count
1765074139	31 Count	2 Count	2 Count
1765073239	30 Count	2 Count	2 Count
1765072338	29 Count	2 Count	2 Count
1765071437	26 Count	0 Count	0 Count
1765070537	25 Count	0 Count	0 Count
1765069636	24 Count	0 Count	0 Count
1765068735	23 Count	0 Count	0 Count
1765067835	22 Count	0 Count	0 Count
1765066934	21 Count	0 Count	0 Count
1765066033	20 Count	0 Count	0 Count
1765065133	19 Count	0 Count	0 Count
1765064232	18 Count	0 Count	0 Count
1765063331	17 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)