EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8C-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773174913	82 Count	520 Count	82 Count
1773174012	82 Count	520 Count	82 Count
1773173112	82 Count	520 Count	82 Count
1773172212	82 Count	520 Count	82 Count
1773171312	82 Count	520 Count	82 Count
1773170412	82 Count	520 Count	82 Count
1773169512	82 Count	520 Count	82 Count
1773168612	82 Count	520 Count	82 Count
1773167712	82 Count	520 Count	82 Count
1773166812	82 Count	520 Count	82 Count
1773165912	82 Count	520 Count	82 Count
1773165012	82 Count	520 Count	82 Count
1773164112	82 Count	520 Count	82 Count
1773163212	82 Count	520 Count	82 Count
1773162312	82 Count	520 Count	82 Count
1773161412	82 Count	520 Count	82 Count
1773160512	82 Count	520 Count	82 Count
1773159612	82 Count	520 Count	82 Count
1773158711	82 Count	520 Count	82 Count
1773157811	82 Count	520 Count	82 Count
1773156911	75 Count	512 Count	75 Count
1773156011	61 Count	483 Count	61 Count
1773155111	61 Count	458 Count	61 Count
1773154211	61 Count	448 Count	61 Count
1773153311	61 Count	443 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)