EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

YU7OPQ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YU7OPQ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765063652	507 Count	76 Count
1765061848	503 Count	76 Count
1765060045	500 Count	76 Count
1765056462	490 Count	72 Count
1765054659	486 Count	70 Count
1765052855	483 Count	68 Count
1765051052	479 Count	66 Count
1765049248	476 Count	64 Count
1765047444	472 Count	62 Count
1765045641	469 Count	60 Count
1765042059	459 Count	54 Count
1765040255	455 Count	52 Count
1765038452	452 Count	50 Count
1765036648	448 Count	46 Count
1765034845	445 Count	44 Count
1765033041	441 Count	42 Count
1765031238	438 Count	38 Count
1765027655	428 Count	34 Count
1765025852	424 Count	32 Count
1765024048	421 Count	32 Count
1765022245	417 Count	32 Count
1765020441	414 Count	32 Count
1765018638	410 Count	32 Count
1765016834	407 Count	29 Count
1765013252	397 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)