EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773147140	37 Count	63 Count	35 Count
1773145339	27 Count	48 Count	26 Count
1773143538	9 Count	23 Count	9 Count
1773141737	746 Count	1015 Count	681 Count
1773139937	738 Count	994 Count	674 Count
1773138136	730 Count	979 Count	667 Count
1773136335	718 Count	961 Count	656 Count
1773134534	705 Count	936 Count	644 Count
1773132734	697 Count	902 Count	637 Count
1773130941	682 Count	851 Count	623 Count
1773129140	671 Count	829 Count	613 Count
1773127340	665 Count	819 Count	608 Count
1773125539	646 Count	798 Count	590 Count
1773123738	639 Count	790 Count	584 Count
1773121937	631 Count	781 Count	577 Count
1773120137	626 Count	775 Count	573 Count
1773118336	621 Count	769 Count	569 Count
1773116535	616 Count	763 Count	565 Count
1773114734	609 Count	755 Count	559 Count
1773112934	605 Count	750 Count	556 Count
1773111133	600 Count	744 Count	552 Count
1773109340	593 Count	736 Count	546 Count
1773107539	585 Count	727 Count	539 Count
1773105739	580 Count	722 Count	535 Count
1773103938	575 Count	716 Count	531 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)