EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1792628642	53 Count	216 Count	42 Count
1792627441	37 Count	161 Count	31 Count
1792626240	24 Count	104 Count	20 Count
1792625040	13 Count	57 Count	11 Count
1792623839	178 Count	1013 Count	137 Count
1792622638	163 Count	940 Count	125 Count
1792621437	150 Count	865 Count	114 Count
1792620236	140 Count	795 Count	106 Count
1792619035	129 Count	722 Count	99 Count
1792617835	121 Count	660 Count	92 Count
1792616634	109 Count	588 Count	83 Count
1792615433	97 Count	523 Count	74 Count
1792614232	81 Count	454 Count	60 Count
1792613031	66 Count	390 Count	49 Count
1792611834	58 Count	329 Count	43 Count
1792610629	49 Count	266 Count	37 Count
1792609445	39 Count	207 Count	29 Count
1792608244	28 Count	152 Count	21 Count
1792607044	18 Count	102 Count	13 Count
1792605843	8 Count	47 Count	6 Count
1792604642	222 Count	1021 Count	163 Count
1792603441	214 Count	970 Count	156 Count
1792602240	204 Count	921 Count	150 Count
1792601039	197 Count	863 Count	144 Count
1792599839	185 Count	801 Count	134 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)