EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EC5CIA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1783102596	0 Count	13 Count
1783101696	0 Count	13 Count
1783100796	0 Count	13 Count
1783099896	0 Count	12 Count
1783098997	0 Count	11 Count
1783098097	0 Count	11 Count
1783097197	0 Count	10 Count
1783096297	0 Count	9 Count
1783095397	0 Count	9 Count
1783094497	0 Count	8 Count
1783093597	0 Count	7 Count
1783092697	0 Count	6 Count
1783091797	0 Count	5 Count
1783090897	0 Count	4 Count
1783089997	0 Count	3 Count
1783089097	0 Count	2 Count
1783088197	0 Count	1 Count
1783087297	112 Count	1017 Count
1783086397	112 Count	988 Count
1783085497	112 Count	987 Count
1783084596	112 Count	986 Count
1783083696	112 Count	985 Count
1783082796	112 Count	984 Count
1783081896	112 Count	983 Count
1783080996	112 Count	982 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)