EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6DJA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6DJA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764942219	0 Count	43 Count
1764940418	97 Count	1027 Count
1764938618	96 Count	962 Count
1764936817	95 Count	926 Count
1764935024	94 Count	913 Count
1764933223	93 Count	874 Count
1764931423	92 Count	862 Count
1764929622	91 Count	850 Count
1764927821	90 Count	840 Count
1764926020	89 Count	830 Count
1764924220	88 Count	819 Count
1764922419	87 Count	810 Count
1764920618	86 Count	794 Count
1764918817	85 Count	780 Count
1764917017	84 Count	770 Count
1764915216	83 Count	761 Count
1764913424	82 Count	750 Count
1764911623	81 Count	737 Count
1764909822	80 Count	725 Count
1764908022	79 Count	712 Count
1764906221	78 Count	700 Count
1764904420	77 Count	688 Count
1764902619	76 Count	676 Count
1764900818	75 Count	666 Count
1764899018	74 Count	655 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)