EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765554925	238 Count	502 Count
1765554447	237 Count	502 Count
1765553843	236 Count	499 Count
1765553240	235 Count	498 Count
1765552637	234 Count	497 Count
1765552033	233 Count	496 Count
1765551430	232 Count	494 Count
1765550826	231 Count	492 Count
1765550223	230 Count	488 Count
1765549620	229 Count	486 Count
1765549016	228 Count	485 Count
1765548413	227 Count	482 Count
1765547809	226 Count	480 Count
1765547206	225 Count	480 Count
1765546603	224 Count	479 Count
1765545998	223 Count	476 Count
1765545395	222 Count	475 Count
1765544792	221 Count	471 Count
1765544188	220 Count	470 Count
1765543584	219 Count	468 Count
1765542981	218 Count	464 Count
1765542377	217 Count	462 Count
1765541774	216 Count	461 Count
1765541171	215 Count	458 Count
1765540567	214 Count	455 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)