EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2RCM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2RCM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764002319	12 Count	624 Count
1763998717	10 Count	558 Count
1763996916	9 Count	486 Count
1763995115	8 Count	423 Count
1763993315	7 Count	337 Count
1763991326	2 Count	267 Count
1763989525	1 Count	184 Count
1763987725	0 Count	69 Count
1763985924	21 Count	1026 Count
1763984123	20 Count	951 Count
1763982322	19 Count	922 Count
1763980522	18 Count	894 Count
1763978721	17 Count	868 Count
1763976920	16 Count	838 Count
1763975119	15 Count	799 Count
1763973319	14 Count	759 Count
1763971518	13 Count	725 Count
1763969720	8 Count	706 Count
1763967920	7 Count	661 Count
1763966119	6 Count	586 Count
1763964318	5 Count	496 Count
1763962518	4 Count	432 Count
1763960717	3 Count	360 Count
1763958916	2 Count	240 Count
1763957115	1 Count	137 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)