EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773163241	427 Count	677 Count	363 Count
1773161438	369 Count	598 Count	313 Count
1773159634	316 Count	500 Count	267 Count
1773157830	261 Count	417 Count	219 Count
1773156026	223 Count	356 Count	188 Count
1773154222	179 Count	293 Count	152 Count
1773152470	142 Count	235 Count	122 Count
1773150666	98 Count	168 Count	85 Count
1773148859	37 Count	73 Count	31 Count
1773147052	675 Count	1069 Count	549 Count
1773145248	636 Count	989 Count	517 Count
1773143445	599 Count	937 Count	487 Count
1773141641	548 Count	867 Count	444 Count
1773139837	475 Count	778 Count	390 Count
1773138033	427 Count	705 Count	349 Count
1773136230	381 Count	632 Count	310 Count
1773134426	349 Count	578 Count	285 Count
1773132622	305 Count	510 Count	248 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)