EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789244277	208 Count	519 Count	83 Count
1789243376	207 Count	518 Count	83 Count
1789242476	206 Count	518 Count	83 Count
1789241593	200 Count	515 Count	82 Count
1789240692	198 Count	513 Count	81 Count
1789239791	196 Count	508 Count	80 Count
1789238890	193 Count	501 Count	78 Count
1789237989	191 Count	493 Count	77 Count
1789237088	189 Count	486 Count	76 Count
1789236188	187 Count	479 Count	75 Count
1789235287	185 Count	470 Count	74 Count
1789234386	184 Count	464 Count	74 Count
1789233485	183 Count	463 Count	74 Count
1789232584	181 Count	461 Count	73 Count
1789231684	179 Count	454 Count	72 Count
1789230783	178 Count	453 Count	72 Count
1789229886	176 Count	441 Count	71 Count
1789228981	175 Count	430 Count	71 Count
1789228081	174 Count	428 Count	71 Count
1789227183	172 Count	426 Count	70 Count
1789226279	170 Count	420 Count	69 Count
1789225378	168 Count	397 Count	68 Count
1789224477	166 Count	392 Count	67 Count
1789223577	164 Count	388 Count	66 Count
1789222676	162 Count	384 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)