EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1792947949	433 Count	861 Count	255 Count
1792947049	430 Count	856 Count	253 Count
1792946148	428 Count	851 Count	252 Count
1792945247	425 Count	847 Count	250 Count
1792944346	422 Count	841 Count	248 Count
1792943445	419 Count	838 Count	246 Count
1792942545	416 Count	832 Count	244 Count
1792941644	413 Count	828 Count	242 Count
1792940743	410 Count	822 Count	240 Count
1792938942	406 Count	817 Count	238 Count
1792938041	405 Count	817 Count	238 Count
1792937140	403 Count	814 Count	237 Count
1792936239	402 Count	814 Count	237 Count
1792935356	396 Count	812 Count	236 Count
1792934455	395 Count	812 Count	236 Count
1792933555	393 Count	808 Count	235 Count
1792932655	391 Count	806 Count	234 Count
1792931753	389 Count	804 Count	233 Count
1792930852	388 Count	802 Count	233 Count
1792929952	385 Count	798 Count	231 Count
1792929051	383 Count	795 Count	230 Count
1792928150	382 Count	792 Count	230 Count
1792927249	381 Count	792 Count	230 Count
1792926349	376 Count	785 Count	226 Count
1792925448	373 Count	779 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)