EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1774003060	5 Count	13 Count
1774002457	4 Count	13 Count
1774001853	3 Count	8 Count
1774001250	2 Count	6 Count
1774000646	1 Count	3 Count
1774000043	0 Count	3 Count
1773999440	719 Count	1002 Count
1773998836	718 Count	1000 Count
1773998354	717 Count	1000 Count
1773997751	716 Count	998 Count
1773997148	715 Count	995 Count
1773996544	714 Count	994 Count
1773995941	713 Count	992 Count
1773995337	712 Count	991 Count
1773994734	711 Count	990 Count
1773994131	710 Count	987 Count
1773993527	709 Count	986 Count
1773992924	708 Count	986 Count
1773992320	707 Count	983 Count
1773991717	706 Count	981 Count
1773991114	705 Count	980 Count
1773990510	704 Count	978 Count
1773989906	703 Count	977 Count
1773989303	702 Count	977 Count
1773988699	701 Count	975 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)