EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4CPM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4CPM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771151213	416 Count	809 Count	346 Count
1771149410	415 Count	809 Count	346 Count
1771147607	414 Count	809 Count	346 Count
1771145804	413 Count	809 Count	346 Count
1771144000	412 Count	809 Count	346 Count
1771142197	409 Count	806 Count	344 Count
1771140436	399 Count	793 Count	335 Count
1771138633	391 Count	783 Count	328 Count
1771136830	382 Count	767 Count	320 Count
1771135026	374 Count	752 Count	313 Count
1771133223	365 Count	734 Count	305 Count
1771131420	356 Count	715 Count	297 Count
1771129617	346 Count	695 Count	288 Count
1771127814	337 Count	677 Count	280 Count
1771126006	328 Count	657 Count	272 Count
1771124203	319 Count	640 Count	264 Count
1771122399	310 Count	620 Count	256 Count
1771120596	301 Count	603 Count	248 Count
1771118839	294 Count	588 Count	242 Count
1771117036	285 Count	572 Count	234 Count
1771115232	275 Count	554 Count	225 Count
1771113429	266 Count	540 Count	217 Count
1771111625	258 Count	521 Count	210 Count
1771109822	248 Count	501 Count	201 Count
1771108019	240 Count	483 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)