EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6VWX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6VWX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1794544830	542 Count	236 Count	123 Count
1794543030	541 Count	236 Count	123 Count
1794541229	540 Count	236 Count	123 Count
1794539428	539 Count	236 Count	123 Count
1794537628	538 Count	236 Count	123 Count
1794535827	537 Count	236 Count	123 Count
1794534027	536 Count	236 Count	123 Count
1794532226	535 Count	236 Count	123 Count
1794528632	533 Count	236 Count	123 Count
1794526831	532 Count	236 Count	123 Count
1794525030	531 Count	236 Count	123 Count
1794523230	530 Count	236 Count	123 Count
1794521429	529 Count	236 Count	123 Count
1794519628	527 Count	235 Count	122 Count
1794517828	526 Count	235 Count	122 Count
1794516027	525 Count	235 Count	122 Count
1794514227	524 Count	235 Count	122 Count
1794512426	523 Count	235 Count	122 Count
1794510625	522 Count	235 Count	122 Count
1794508832	515 Count	229 Count	116 Count
1794507031	512 Count	227 Count	114 Count
1794505230	511 Count	227 Count	114 Count
1794503430	510 Count	227 Count	114 Count
1794501629	509 Count	227 Count	114 Count
1794499828	508 Count	227 Count	114 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)