EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789244966	400 Count	547 Count	353 Count
1789244066	394 Count	540 Count	348 Count
1789243260	390 Count	536 Count	345 Count
1789242356	385 Count	528 Count	341 Count
1789241451	380 Count	520 Count	337 Count
1789240547	375 Count	514 Count	333 Count
1789239643	370 Count	508 Count	329 Count
1789238739	364 Count	498 Count	324 Count
1789237835	360 Count	489 Count	321 Count
1789236931	356 Count	483 Count	318 Count
1789236027	351 Count	476 Count	314 Count
1789235123	347 Count	469 Count	311 Count
1789234219	341 Count	460 Count	306 Count
1789233315	336 Count	453 Count	302 Count
1789232407	330 Count	446 Count	297 Count
1789231503	325 Count	437 Count	293 Count
1789230599	319 Count	425 Count	288 Count
1789229695	313 Count	418 Count	283 Count
1789228791	308 Count	409 Count	279 Count
1789227887	301 Count	400 Count	273 Count
1789226982	296 Count	393 Count	269 Count
1789226077	291 Count	387 Count	265 Count
1789225173	286 Count	381 Count	261 Count
1789224273	281 Count	376 Count	257 Count
1789223365	276 Count	370 Count	253 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)