EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793057663	510 Count	971 Count	411 Count
1793056759	505 Count	965 Count	407 Count
1793055855	502 Count	960 Count	405 Count
1793054951	498 Count	953 Count	402 Count
1793054047	496 Count	943 Count	401 Count
1793053143	491 Count	936 Count	397 Count
1793052238	488 Count	931 Count	395 Count
1793051334	484 Count	924 Count	392 Count
1793050430	482 Count	920 Count	391 Count
1793049525	477 Count	914 Count	387 Count
1793048621	474 Count	909 Count	385 Count
1793047717	470 Count	902 Count	382 Count
1793046813	467 Count	897 Count	380 Count
1793045909	461 Count	887 Count	375 Count
1793045005	458 Count	882 Count	373 Count
1793044101	454 Count	875 Count	370 Count
1793043197	451 Count	870 Count	368 Count
1793042289	446 Count	864 Count	364 Count
1793041385	442 Count	858 Count	361 Count
1793040484	438 Count	851 Count	358 Count
1793039576	433 Count	844 Count	354 Count
1793038773	429 Count	838 Count	351 Count
1793037869	425 Count	832 Count	348 Count
1793036965	420 Count	824 Count	344 Count
1793036061	417 Count	821 Count	342 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)