EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767297457	132 Count	369 Count	115 Count
1767295654	125 Count	341 Count	109 Count
1767293851	118 Count	313 Count	103 Count
1767292048	109 Count	285 Count	95 Count
1767290245	102 Count	259 Count	89 Count
1767288442	95 Count	231 Count	83 Count
1767286672	84 Count	204 Count	77 Count
1767284869	76 Count	182 Count	70 Count
1767283066	66 Count	155 Count	61 Count
1767279460	44 Count	104 Count	41 Count
1767277657	33 Count	77 Count	31 Count
1767275854	24 Count	56 Count	23 Count
1767274051	11 Count	25 Count	11 Count
1767272248	335 Count	1004 Count	292 Count
1767270445	326 Count	979 Count	284 Count
1767268642	315 Count	957 Count	274 Count
1767266839	304 Count	926 Count	264 Count
1767265074	288 Count	901 Count	253 Count
1767263271	277 Count	876 Count	243 Count
1767261468	266 Count	849 Count	233 Count
1767257862	240 Count	785 Count	209 Count
1767256059	230 Count	753 Count	200 Count
1767254256	221 Count	720 Count	192 Count
1767252454	211 Count	691 Count	183 Count
1767250646	199 Count	657 Count	172 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)