EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767316039	969 Count	448 Count	428 Count
1767314238	967 Count	447 Count	427 Count
1767312438	965 Count	446 Count	426 Count
1767310637	963 Count	445 Count	425 Count
1767308836	961 Count	444 Count	424 Count
1767307035	960 Count	444 Count	424 Count
1767305235	959 Count	444 Count	424 Count
1767303434	957 Count	443 Count	423 Count
1767301640	951 Count	442 Count	422 Count
1767299841	949 Count	441 Count	421 Count
1767298039	948 Count	441 Count	421 Count
1767296238	947 Count	441 Count	421 Count
1767294438	946 Count	441 Count	421 Count
1767292637	945 Count	441 Count	421 Count
1767290837	943 Count	440 Count	420 Count
1767287236	940 Count	439 Count	419 Count
1767285435	938 Count	438 Count	418 Count
1767283635	936 Count	437 Count	417 Count
1767281833	934 Count	436 Count	416 Count
1767280039	928 Count	435 Count	415 Count
1767278239	923 Count	431 Count	411 Count
1767276439	921 Count	430 Count	410 Count
1767274639	919 Count	429 Count	409 Count
1767272837	917 Count	428 Count	408 Count
1767271036	915 Count	427 Count	407 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)