EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1772104220	631 Count	649 Count	291 Count
1772102419	628 Count	572 Count	289 Count
1772100618	625 Count	493 Count	287 Count
1772098818	622 Count	444 Count	285 Count
1772097017	619 Count	442 Count	283 Count
1772095217	616 Count	437 Count	281 Count
1772093416	613 Count	434 Count	279 Count
1772091615	610 Count	430 Count	277 Count
1772089815	607 Count	427 Count	275 Count
1772088021	600 Count	424 Count	273 Count
1772086220	597 Count	421 Count	271 Count
1772084420	594 Count	418 Count	269 Count
1772082619	591 Count	415 Count	267 Count
1772080818	588 Count	411 Count	265 Count
1772079018	585 Count	406 Count	263 Count
1772077217	582 Count	401 Count	261 Count
1772075417	579 Count	397 Count	259 Count
1772073616	576 Count	393 Count	257 Count
1772071816	573 Count	390 Count	255 Count
1772070015	572 Count	388 Count	255 Count
1772068214	570 Count	386 Count	254 Count
1772066421	564 Count	384 Count	253 Count
1772064620	562 Count	382 Count	252 Count
1772062819	560 Count	380 Count	251 Count
1772061018	558 Count	378 Count	250 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)