EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SZ1SV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SZ1SV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1773722811	89 Count	46 Count	20 Count
1773721907	88 Count	46 Count	20 Count
1773721004	87 Count	46 Count	20 Count
1773720101	86 Count	46 Count	20 Count
1773719198	85 Count	46 Count	20 Count
1773718295	84 Count	46 Count	20 Count
1773717392	82 Count	45 Count	19 Count
1773716489	81 Count	45 Count	19 Count
1773715586	80 Count	45 Count	19 Count
1773714683	78 Count	44 Count	18 Count
1773713780	77 Count	44 Count	18 Count
1773712877	76 Count	44 Count	18 Count
1773711974	74 Count	43 Count	17 Count
1773711071	73 Count	43 Count	17 Count
1773710167	72 Count	43 Count	17 Count
1773709264	71 Count	43 Count	17 Count
1773708361	70 Count	43 Count	17 Count
1773707458	69 Count	43 Count	17 Count
1773706555	68 Count	43 Count	17 Count
1773705652	67 Count	43 Count	17 Count
1773704749	66 Count	43 Count	17 Count
1773703846	65 Count	43 Count	17 Count
1773702943	64 Count	43 Count	17 Count
1773702040	63 Count	43 Count	17 Count
1773701137	62 Count	43 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)