EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

AJ6WO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AJ6WO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1783181173	851 Count	647 Count	305 Count
1783180569	850 Count	647 Count	305 Count
1783179966	849 Count	647 Count	305 Count
1783179363	848 Count	647 Count	305 Count
1783178759	847 Count	647 Count	305 Count
1783178156	846 Count	647 Count	305 Count
1783177553	845 Count	647 Count	305 Count
1783176949	844 Count	647 Count	305 Count
1783176346	843 Count	647 Count	305 Count
1783175742	842 Count	647 Count	305 Count
1783175139	841 Count	647 Count	305 Count
1783174536	840 Count	647 Count	305 Count
1783173932	839 Count	647 Count	305 Count
1783173329	838 Count	647 Count	305 Count
1783172726	837 Count	647 Count	305 Count
1783172122	836 Count	647 Count	305 Count
1783171519	835 Count	647 Count	305 Count
1783170915	832 Count	643 Count	303 Count
1783170312	829 Count	639 Count	301 Count
1783169708	828 Count	637 Count	301 Count
1783169105	827 Count	635 Count	301 Count
1783168501	826 Count	633 Count	301 Count
1783167898	825 Count	631 Count	301 Count
1783167295	824 Count	629 Count	301 Count
1783166691	823 Count	627 Count	301 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)