EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765852352	33 Count	124 Count	32 Count
1765850551	19 Count	68 Count	19 Count
1765848751	293 Count	1035 Count	279 Count
1765846950	271 Count	969 Count	258 Count
1765845149	251 Count	909 Count	239 Count
1765843349	232 Count	830 Count	221 Count
1765841548	210 Count	756 Count	200 Count
1765839747	191 Count	694 Count	182 Count
1765837947	169 Count	626 Count	161 Count
1765836146	150 Count	553 Count	143 Count
1765834345	135 Count	489 Count	129 Count
1765832552	116 Count	414 Count	111 Count
1765830751	94 Count	342 Count	90 Count
1765828950	73 Count	269 Count	70 Count
1765827150	55 Count	201 Count	53 Count
1765825349	36 Count	135 Count	35 Count
1765823548	16 Count	69 Count	16 Count
1765821748	352 Count	1062 Count	338 Count
1765819947	333 Count	994 Count	320 Count
1765818146	314 Count	933 Count	302 Count
1765816345	295 Count	875 Count	284 Count
1765814545	277 Count	811 Count	267 Count
1765812744	253 Count	734 Count	244 Count
1765810953	230 Count	665 Count	222 Count
1765809152	215 Count	606 Count	208 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)