EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8XY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8XY-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767303792	51 Count	443 Count	22 Count
1767301992	50 Count	438 Count	22 Count
1767300191	48 Count	434 Count	21 Count
1767298390	47 Count	433 Count	21 Count
1767296590	46 Count	432 Count	21 Count
1767294789	45 Count	426 Count	21 Count
1767292988	42 Count	422 Count	19 Count
1767291188	40 Count	411 Count	18 Count
1767289387	39 Count	403 Count	18 Count
1767287586	38 Count	393 Count	18 Count
1767285795	37 Count	387 Count	18 Count
1767283994	36 Count	384 Count	18 Count
1767282193	35 Count	376 Count	18 Count
1767280393	33 Count	374 Count	17 Count
1767278592	32 Count	369 Count	17 Count
1767276791	31 Count	363 Count	17 Count
1767274991	30 Count	359 Count	17 Count
1767273190	29 Count	354 Count	17 Count
1767271389	28 Count	343 Count	17 Count
1767269589	27 Count	338 Count	17 Count
1767264194	21 Count	278 Count	14 Count
1767262393	19 Count	259 Count	13 Count
1767260592	16 Count	228 Count	11 Count
1767258792	14 Count	194 Count	10 Count
1767256991	10 Count	157 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)