EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8XY-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8XY-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765874546	293 Count	146 Count	105 Count
1765872745	292 Count	140 Count	105 Count
1765870944	291 Count	135 Count	105 Count
1765869144	290 Count	135 Count	105 Count
1765867343	288 Count	130 Count	104 Count
1765865542	286 Count	119 Count	103 Count
1765863741	285 Count	111 Count	103 Count
1765861941	284 Count	103 Count	103 Count
1765860147	283 Count	103 Count	103 Count
1765858346	273 Count	94 Count	94 Count
1765856545	267 Count	89 Count	89 Count
1765854745	266 Count	89 Count	89 Count
1765852944	265 Count	89 Count	89 Count
1765851143	264 Count	89 Count	89 Count
1765849342	263 Count	89 Count	89 Count
1765847542	262 Count	89 Count	89 Count
1765845741	261 Count	89 Count	89 Count
1765843940	260 Count	89 Count	89 Count
1765842140	259 Count	89 Count	89 Count
1765840339	258 Count	89 Count	89 Count
1765838548	256 Count	88 Count	88 Count
1765836748	253 Count	86 Count	86 Count
1765834947	252 Count	86 Count	86 Count
1765833146	251 Count	86 Count	86 Count
1765831346	250 Count	86 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)