EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762368517	65 Count	323 Count	41 Count
1762367616	63 Count	315 Count	40 Count
1762366715	60 Count	302 Count	38 Count
1762365814	58 Count	291 Count	37 Count
1762364914	55 Count	282 Count	35 Count
1762364013	53 Count	272 Count	34 Count
1762363112	50 Count	258 Count	32 Count
1762362211	48 Count	246 Count	31 Count
1762361311	45 Count	237 Count	29 Count
1762360410	43 Count	225 Count	28 Count
1762359524	40 Count	212 Count	26 Count
1762358623	38 Count	201 Count	25 Count
1762357722	35 Count	192 Count	23 Count
1762356821	33 Count	171 Count	22 Count
1762355920	30 Count	145 Count	20 Count
1762354119	21 Count	102 Count	13 Count
1762353218	19 Count	92 Count	12 Count
1762352318	16 Count	78 Count	10 Count
1762351417	14 Count	66 Count	9 Count
1762350516	11 Count	57 Count	7 Count
1762349615	9 Count	45 Count	6 Count
1762348715	6 Count	32 Count	4 Count
1762347814	4 Count	21 Count	3 Count
1762346913	1 Count	12 Count	1 Count
1762346012	236 Count	1001 Count	156 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)