EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762520897	49 Count	250 Count	32 Count
1762519996	46 Count	235 Count	30 Count
1762519095	44 Count	221 Count	29 Count
1762518195	41 Count	210 Count	27 Count
1762517294	39 Count	197 Count	26 Count
1762516409	36 Count	182 Count	24 Count
1762515508	34 Count	169 Count	23 Count
1762514608	31 Count	159 Count	21 Count
1762513707	29 Count	147 Count	20 Count
1762512806	26 Count	132 Count	18 Count
1762511905	24 Count	119 Count	17 Count
1762511004	21 Count	109 Count	15 Count
1762510104	19 Count	97 Count	14 Count
1762509203	16 Count	85 Count	12 Count
1762508302	14 Count	72 Count	11 Count
1762507401	11 Count	63 Count	9 Count
1762506501	9 Count	50 Count	8 Count
1762505600	3 Count	27 Count	3 Count
1762504699	215 Count	1026 Count	134 Count
1762503798	211 Count	997 Count	131 Count
1762502898	208 Count	976 Count	129 Count
1762501997	205 Count	962 Count	127 Count
1762501096	203 Count	950 Count	126 Count
1762500195	200 Count	941 Count	124 Count
1762499295	198 Count	929 Count	123 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)