EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789267594	136 Count	509 Count	119 Count
1789265791	127 Count	478 Count	111 Count
1789263988	120 Count	446 Count	105 Count
1789262185	111 Count	412 Count	97 Count
1789260382	103 Count	378 Count	90 Count
1789258579	94 Count	342 Count	82 Count
1789256776	84 Count	301 Count	73 Count
1789254973	75 Count	266 Count	65 Count
1789253208	63 Count	231 Count	58 Count
1789251405	53 Count	194 Count	49 Count
1789249597	43 Count	156 Count	40 Count
1789247794	32 Count	116 Count	30 Count
1789245991	22 Count	82 Count	21 Count
1789244188	11 Count	38 Count	11 Count
1789242385	215 Count	1045 Count	190 Count
1789240582	206 Count	998 Count	182 Count
1789238779	194 Count	930 Count	171 Count
1789236976	182 Count	876 Count	160 Count
1789235173	169 Count	823 Count	148 Count
1789233370	158 Count	771 Count	138 Count
1789231609	144 Count	731 Count	129 Count
1789229806	127 Count	686 Count	113 Count
1789228001	109 Count	608 Count	96 Count
1789226198	95 Count	485 Count	83 Count
1789224395	82 Count	407 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)