EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793184912	15 Count	74 Count	15 Count
1793183109	451 Count	1030 Count	420 Count
1793181306	429 Count	984 Count	399 Count
1793179503	405 Count	937 Count	376 Count
1793177700	384 Count	896 Count	356 Count
1793175897	366 Count	855 Count	339 Count
1793174094	348 Count	814 Count	322 Count
1793172291	330 Count	772 Count	305 Count
1793170488	315 Count	736 Count	291 Count
1793168685	296 Count	693 Count	273 Count
1793166881	277 Count	650 Count	255 Count
1793165079	260 Count	612 Count	239 Count
1793163309	235 Count	553 Count	219 Count
1793161506	219 Count	514 Count	204 Count
1793159703	202 Count	478 Count	188 Count
1793157900	188 Count	442 Count	175 Count
1793156097	166 Count	401 Count	154 Count
1793154294	146 Count	354 Count	135 Count
1793152491	134 Count	318 Count	124 Count
1793150688	119 Count	280 Count	110 Count
1793148885	95 Count	234 Count	87 Count
1793147082	78 Count	190 Count	71 Count
1793145279	53 Count	138 Count	47 Count
1793143476	35 Count	90 Count	30 Count
1793141706	9 Count	36 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)