EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8RPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8RPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775418787	117 Count	557 Count	109 Count
1775416386	70 Count	322 Count	64 Count
1775413984	21 Count	101 Count	18 Count
1775411597	352 Count	983 Count	347 Count
1775409195	269 Count	685 Count	266 Count
1775404392	328 Count	1054 Count	312 Count
1775401990	280 Count	896 Count	266 Count
1775399588	224 Count	720 Count	212 Count
1775397186	172 Count	553 Count	162 Count
1775394785	128 Count	399 Count	120 Count
1775392383	77 Count	226 Count	72 Count
1775389996	24 Count	84 Count	24 Count
1775387594	373 Count	954 Count	363 Count
1775385192	332 Count	829 Count	324 Count
1775380392	169 Count	459 Count	165 Count
1775377987	74 Count	251 Count	72 Count
1775375585	25 Count	85 Count	25 Count
1775373184	293 Count	989 Count	280 Count
1775370782	232 Count	794 Count	222 Count
1775368395	178 Count	618 Count	173 Count
1775365993	112 Count	404 Count	109 Count
1775363591	61 Count	226 Count	60 Count
1775361190	255 Count	1044 Count	248 Count
1775358788	201 Count	808 Count	196 Count
1775356386	150 Count	574 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)