EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IW0EFI-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW0EFI-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773749789	428 Count	33 Count
1773748889	427 Count	33 Count
1773747989	426 Count	33 Count
1773747088	427 Count	33 Count
1773746188	428 Count	33 Count
1773745288	427 Count	33 Count
1773743488	425 Count	33 Count
1773742598	427 Count	33 Count
1773741687	427 Count	33 Count
1773740787	425 Count	33 Count
1773738987	429 Count	33 Count
1773738087	425 Count	33 Count
1773737186	427 Count	33 Count
1773736286	426 Count	33 Count
1773735386	425 Count	33 Count
1773734486	428 Count	33 Count
1773733586	428 Count	33 Count
1773732685	428 Count	33 Count
1773731785	426 Count	33 Count
1773730885	426 Count	33 Count
1773729985	426 Count	33 Count
1773729085	427 Count	33 Count
1773728184	427 Count	33 Count
1773727284	427 Count	33 Count
1773726384	427 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)