EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793189046	955 Count	919 Count	435 Count
1793187246	953 Count	918 Count	434 Count
1793185445	951 Count	917 Count	433 Count
1793183651	945 Count	916 Count	432 Count
1793181851	943 Count	915 Count	431 Count
1793180050	941 Count	914 Count	430 Count
1793178249	939 Count	913 Count	429 Count
1793176449	937 Count	912 Count	428 Count
1793174648	935 Count	911 Count	427 Count
1793172847	933 Count	910 Count	426 Count
1793171047	931 Count	909 Count	425 Count
1793169246	929 Count	908 Count	424 Count
1793167446	927 Count	907 Count	423 Count
1793165645	925 Count	906 Count	422 Count
1793163844	923 Count	905 Count	421 Count
1793162050	917 Count	904 Count	420 Count
1793160250	915 Count	903 Count	419 Count
1793158449	913 Count	902 Count	418 Count
1793156649	911 Count	901 Count	417 Count
1793154848	909 Count	900 Count	416 Count
1793153047	907 Count	899 Count	415 Count
1793151247	905 Count	898 Count	414 Count
1793149446	903 Count	897 Count	413 Count
1793147646	901 Count	896 Count	412 Count
1793145846	899 Count	895 Count	411 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)