EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793186217	966 Count	781 Count	339 Count
1793184416	965 Count	781 Count	339 Count
1793180815	963 Count	781 Count	339 Count
1793179956	962 Count	781 Count	339 Count
1793178155	961 Count	781 Count	339 Count
1793176354	960 Count	781 Count	339 Count
1793174554	954 Count	776 Count	334 Count
1793172753	953 Count	776 Count	334 Count
1793170952	952 Count	776 Count	334 Count
1793169152	951 Count	776 Count	334 Count
1793167350	950 Count	776 Count	334 Count
1793132219	947 Count	776 Count	334 Count
1793130418	946 Count	776 Count	334 Count
1793128618	945 Count	776 Count	334 Count
1793126817	944 Count	776 Count	334 Count
1793125016	943 Count	776 Count	334 Count
1793123216	942 Count	776 Count	334 Count
1793121415	941 Count	776 Count	334 Count
1793119614	940 Count	776 Count	334 Count
1793117813	939 Count	776 Count	334 Count
1793116013	938 Count	776 Count	334 Count
1793114219	937 Count	776 Count	334 Count
1793112419	936 Count	776 Count	334 Count
1793110618	935 Count	776 Count	334 Count
1793108818	934 Count	776 Count	334 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)