EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773666597	975 Count	805 Count	309 Count
1773662996	969 Count	794 Count	305 Count
1773659395	966 Count	790 Count	304 Count
1773655793	960 Count	780 Count	300 Count
1773652191	953 Count	771 Count	295 Count
1773648590	939 Count	753 Count	283 Count
1773644997	933 Count	745 Count	279 Count
1773637794	927 Count	739 Count	277 Count
1773634193	925 Count	735 Count	277 Count
1773630591	922 Count	731 Count	276 Count
1773626989	919 Count	728 Count	275 Count
1773623396	916 Count	722 Count	274 Count
1773619794	910 Count	714 Count	270 Count
1773616192	906 Count	705 Count	268 Count
1773612591	900 Count	692 Count	264 Count
1773608989	895 Count	681 Count	261 Count
1773605388	890 Count	673 Count	258 Count
1773601795	887 Count	669 Count	257 Count
1773598193	884 Count	664 Count	256 Count
1773594592	878 Count	655 Count	252 Count
1773590991	873 Count	646 Count	249 Count
1773587390	869 Count	637 Count	247 Count
1773583788	857 Count	619 Count	237 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)