EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762380710	403 Count	42 Count
1762378909	402 Count	42 Count
1762377109	401 Count	42 Count
1762375308	400 Count	42 Count
1762373507	399 Count	42 Count
1762369905	397 Count	42 Count
1762368104	396 Count	42 Count
1762366303	395 Count	42 Count
1762364503	394 Count	42 Count
1762362711	393 Count	42 Count
1762360911	392 Count	42 Count
1762359110	391 Count	42 Count
1762357308	390 Count	42 Count
1762355508	389 Count	42 Count
1762353707	388 Count	42 Count
1762351906	387 Count	42 Count
1762350105	386 Count	42 Count
1762348304	385 Count	42 Count
1762346504	384 Count	42 Count
1762344703	383 Count	42 Count
1762342902	382 Count	42 Count
1762341110	381 Count	42 Count
1762339309	380 Count	42 Count
1762337508	379 Count	42 Count
1762335707	378 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)