EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771682207	593 Count	146 Count
1771680417	592 Count	146 Count
1771676815	590 Count	146 Count
1771675014	589 Count	146 Count
1771673213	588 Count	146 Count
1771671412	587 Count	146 Count
1771669611	586 Count	146 Count
1771666009	584 Count	146 Count
1771664209	583 Count	146 Count
1771662408	582 Count	146 Count
1771660607	581 Count	146 Count
1771658816	580 Count	146 Count
1771655214	578 Count	146 Count
1771653413	577 Count	146 Count
1771651612	576 Count	146 Count
1771649811	575 Count	146 Count
1771648010	574 Count	146 Count
1771644408	572 Count	146 Count
1771642607	571 Count	146 Count
1771640807	570 Count	146 Count
1771637213	568 Count	146 Count
1771633612	566 Count	146 Count
1771631811	565 Count	146 Count
1771630010	564 Count	146 Count
1771622807	560 Count	146 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)