EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769015773	15 Count	198 Count	0 Count
1769013972	14 Count	196 Count	0 Count
1769012170	13 Count	194 Count	0 Count
1769010369	12 Count	192 Count	0 Count
1769008568	11 Count	185 Count	0 Count
1769006767	10 Count	183 Count	0 Count
1769004966	9 Count	181 Count	0 Count
1769003172	8 Count	179 Count	0 Count
1769001371	7 Count	177 Count	0 Count
1768999571	6 Count	173 Count	0 Count
1768997770	5 Count	152 Count	0 Count
1768995969	4 Count	123 Count	0 Count
1768994169	2 Count	92 Count	0 Count
1768992368	1 Count	61 Count	0 Count
1768990568	0 Count	29 Count	0 Count
1768988767	410 Count	1027 Count	76 Count
1768981576	406 Count	932 Count	76 Count
1768979775	405 Count	930 Count	76 Count
1768977974	404 Count	928 Count	76 Count
1768976173	403 Count	926 Count	76 Count
1768974373	402 Count	924 Count	76 Count
1768972571	401 Count	922 Count	76 Count
1768970771	400 Count	920 Count	76 Count
1768968970	399 Count	918 Count	76 Count
1768967169	398 Count	916 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)