EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773741975	397 Count	981 Count	198 Count
1773740174	395 Count	976 Count	197 Count
1773738372	393 Count	971 Count	196 Count
1773736571	391 Count	966 Count	195 Count
1773734770	389 Count	961 Count	194 Count
1773732969	387 Count	956 Count	193 Count
1773731168	385 Count	946 Count	192 Count
1773729368	383 Count	941 Count	191 Count
1773727577	381 Count	936 Count	190 Count
1773725776	379 Count	931 Count	189 Count
1773723975	377 Count	926 Count	188 Count
1773722174	375 Count	922 Count	187 Count
1773720373	373 Count	917 Count	186 Count
1773718573	371 Count	913 Count	185 Count
1773716772	369 Count	909 Count	184 Count
1773714971	367 Count	905 Count	183 Count
1773713170	365 Count	900 Count	182 Count
1773711369	363 Count	895 Count	181 Count
1773709568	361 Count	884 Count	180 Count
1773707767	359 Count	879 Count	179 Count
1773705975	357 Count	875 Count	178 Count
1773704174	355 Count	871 Count	177 Count
1773702374	353 Count	867 Count	176 Count
1773700573	351 Count	863 Count	175 Count
1773698772	349 Count	859 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)