EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785112799	212 Count	560 Count
1785110998	211 Count	558 Count
1785109197	210 Count	556 Count
1785107397	209 Count	553 Count
1785105597	208 Count	550 Count
1785103796	207 Count	548 Count
1785101997	206 Count	542 Count
1785100197	205 Count	540 Count
1785098399	204 Count	533 Count
1785096598	203 Count	531 Count
1785094796	202 Count	529 Count
1785087597	198 Count	521 Count
1785085796	197 Count	519 Count
1785083996	196 Count	517 Count
1785082196	195 Count	515 Count
1785080396	194 Count	513 Count
1785078595	193 Count	511 Count
1785076796	192 Count	504 Count
1785074996	191 Count	502 Count
1785069596	188 Count	496 Count
1785067795	187 Count	494 Count
1785065995	186 Count	492 Count
1785062395	184 Count	488 Count
1785060595	183 Count	486 Count
1785056994	181 Count	483 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)