EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR1NRD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR1NRD-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765071143	20 Count	14 Count
1765070543	19 Count	14 Count
1765069942	18 Count	13 Count
1765069341	17 Count	12 Count
1765068741	16 Count	12 Count
1765068140	15 Count	11 Count
1765067539	14 Count	10 Count
1765066939	13 Count	10 Count
1765066338	12 Count	9 Count
1765065737	11 Count	8 Count
1765065136	10 Count	8 Count
1765064536	9 Count	6 Count
1765063935	8 Count	6 Count
1765063334	7 Count	5 Count
1765062734	6 Count	4 Count
1765062133	5 Count	4 Count
1765061532	4 Count	3 Count
1765060931	3 Count	2 Count
1765060331	2 Count	2 Count
1765059730	1 Count	1 Count
1765059129	0 Count	0 Count
1765058529	1000 Count	75 Count
1765057361	999 Count	73 Count
1765056760	998 Count	73 Count
1765056160	997 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)