EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767327686	15 Count	9 Count	7 Count
1767327085	13 Count	7 Count	6 Count
1767326485	12 Count	6 Count	6 Count
1767325884	10 Count	5 Count	5 Count
1767325283	8 Count	4 Count	4 Count
1767324683	7 Count	4 Count	4 Count
1767324082	5 Count	3 Count	3 Count
1767323482	3 Count	2 Count	2 Count
1767322881	2 Count	2 Count	2 Count
1767322280	579 Count	1001 Count	322 Count
1767321680	576 Count	999 Count	320 Count
1767321079	575 Count	999 Count	320 Count
1767320478	573 Count	998 Count	319 Count
1767319878	570 Count	996 Count	317 Count
1767319277	569 Count	996 Count	317 Count
1767318677	567 Count	995 Count	316 Count
1767318076	565 Count	994 Count	315 Count
1767317475	564 Count	993 Count	315 Count
1767316875	562 Count	992 Count	314 Count
1767316274	559 Count	990 Count	312 Count
1767315673	558 Count	990 Count	312 Count
1767315072	556 Count	989 Count	311 Count
1767314471	553 Count	987 Count	309 Count
1767313871	552 Count	986 Count	309 Count
1767313270	549 Count	983 Count	307 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)