EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765076400	412 Count	704 Count	247 Count
1765075799	409 Count	701 Count	245 Count
1765075198	406 Count	699 Count	243 Count
1765074598	405 Count	698 Count	243 Count
1765073997	402 Count	694 Count	241 Count
1765073397	399 Count	692 Count	239 Count
1765072796	398 Count	691 Count	239 Count
1765072195	395 Count	688 Count	237 Count
1765071595	392 Count	686 Count	235 Count
1765070994	391 Count	685 Count	235 Count
1765070393	388 Count	682 Count	233 Count
1765069793	385 Count	680 Count	231 Count
1765069192	384 Count	679 Count	231 Count
1765068590	381 Count	676 Count	229 Count
1765067990	378 Count	673 Count	227 Count
1765067389	377 Count	672 Count	227 Count
1765066789	374 Count	669 Count	225 Count
1765066188	371 Count	666 Count	223 Count
1765065587	370 Count	665 Count	223 Count
1765064986	367 Count	662 Count	221 Count
1765064386	364 Count	660 Count	219 Count
1765063785	363 Count	659 Count	219 Count
1765063184	361 Count	657 Count	218 Count
1765062583	358 Count	655 Count	216 Count
1765061982	357 Count	653 Count	216 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)