EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0UQT-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0UQT-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765071223	15 Count	160 Count
1765070320	14 Count	148 Count
1765069417	13 Count	139 Count
1765068513	12 Count	128 Count
1765067610	11 Count	117 Count
1765066707	10 Count	106 Count
1765065804	9 Count	96 Count
1765064901	8 Count	86 Count
1765063997	7 Count	75 Count
1765063094	6 Count	64 Count
1765062191	5 Count	52 Count
1765061288	4 Count	44 Count
1765060385	3 Count	33 Count
1765060253	2 Count	29 Count
1765059664	1 Count	21 Count
1765058761	0 Count	9 Count
1765058015	107 Count	1013 Count
1765057112	106 Count	1000 Count
1765056209	105 Count	991 Count
1765055306	104 Count	976 Count
1765054402	103 Count	966 Count
1765053499	102 Count	952 Count
1765052595	101 Count	942 Count
1765051692	100 Count	925 Count
1765050789	99 Count	915 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)